Get matched with top pressure washers in Elephant Butte, NM

Yes, pressure washers can remove rust stains from concrete. However, when coupled with an acid treatment, they can be even more effective. Just be sure to use a minimum of a 15-degree nozzle to prevent damage to the surface, and users must also be careful not to get in the way of the pressure washer’s jet as they can cut through skin and cause injury. 

This answer is a bit tricky because experts say both. You should apply your cleaning solution from bottom to top, but rinse from top to bottom to avoid streaking. When it comes to multi-story houses, you’ll want to start at the top floor and work your way down, but follow the above instructions for each level as if it were an independent structure, rather than washing the whole house as one unit.

A pressure washer is okay to use on epoxy floors and won’t remove the concrete coating if you use a lower pressure setting and the correct nozzle, such as a green, white, or black nozzle, for gentle cleaning. Be careful using a power washer, which adds heat to the pressurized water, because this may be too powerful and could damage the epoxy.

Yes, you can pressure wash with just water. The force of the water alone is often enough to remove dirt, grime, and debris from many surfaces. However, for tougher stains like grease, mildew, or algae, adding a detergent or cleaning solution can enhance the cleaning power. Be sure to use the appropriate nozzle and pressure settings for the surface to achieve the best results without causing damage.