Get matched with top deck cleaning pros in Lincoln, NH

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Yes, it is possible to build a small, basic deck for $5,000, particularly if you use less expensive materials and a simple design. To stay within this budget, consider a size under 10x12 feet and use affordable materials like pressure-treated wood or cedar. While the general cost for deck building ranges from $4,350 to $12,560, with an average around $8,200, some projects can be completed for as little as $4,350. You can also save on labor costs by doing the work yourself, but be aware that mistakes could end up costing more than hiring a professional. A contractor may have a higher upfront cost, but they can ensure a safe, stable deck that will last.

Unless you’re using a 2-in-1 formula or painting over an existing coat of paint, it pays to apply a coat of primer ahead of your new paint. Decks see a lot of footfall and exposure to extreme and sudden temperature changes and moisture levels. The primer promotes better paint adhesion, moisture repellency, and a smoother finish, which means you’ll often need fewer coats of paint. 

Building codes for deck railings can vary by location, so it's important to consult your local regulations before construction. Generally, a guardrail is required for any deck that is more than 30 inches above the ground.

For residential properties, the standard minimum height for a deck railing is 36 inches. However, some states and municipalities have stricter requirements; for example, California and Washington mandate railings that are at least 42 inches high. Therefore, a 42-inch railing is not considered too high and may be required in your area or chosen voluntarily for additional safety.

In addition to height requirements, codes also specify other safety features, such as the maximum spacing between balusters to ensure they are close enough to prevent a child from squeezing through.