Get matched with top drain pipe installers in York, NE

A sewage ejector pump works to move solid waste and wastewater from below ground, basement fixtures up into the main sewer line of the home, where it can then drain out into the city sewer system or your septic tank. Without a sewage ejector pump, this wastewater would simply pool and flood your basement.

A back pressure valve is a control valve used on production vessels, such as separators, treaters, and free water knockouts. The valve holds pressure until a set point is reached, and then releases upstream pressure to reset. Back pressure valves are not safety mechanisms. Instead, they are regulators designed to keep the fluid, gas, or liquid mixture in a system at a certain pressure level to prevent bursts and other incidents.

Meanwhile, a backflow preventer is a safety mechanism that kicks in when the pressure has already failed and contaminated water flows in the reverse direction. Most backflow preventers consist of two one-way valves, or check valves assembled together. This design only allows water to pass through in one direction but not the other.

A chipped bathtub could leak over time if you don’t take care of the issue. A tiny chip isn’t a big deal but may eventually grow into a larger crack. As the months go by, the tub’s barrier against moisture becomes weakened, making it prone to leaking. Large chips can also cause the tub to rust and even crack in half.

Removing calcium and lime buildup will often fix a clogged faucet head. You can usually remove any buildup with distilled white vinegar or a combination of vinegar, dish soap, and baking soda. Sometimes, the problem is buildup on the aerator, in which case removing and cleaning that part should fix your water flow. However, the design of some aerators makes them difficult to clean. For those, replacing the aerator will get the faucet flowing well again.