Get matched with top drywall pros in Stromsburg, NE

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

Generally, shower walls should not be installed over drywall because of the moisture issues this can cause. If you’re using a direct-to-stud shower kit, you need to remove the drywall before you can do the installation.

However, if you’re using a glue-up shower kit or stall, you can glue the shower walls directly to drywall. Be sure to install a moisture-resistant drywall or waterproof cement board.

The two most common types of drywall are ½-inch and ⅝-inch thick white or gray drywall. Most walls are ⅝-inch thick because the drywall is slightly more resistant to damage and it helps dampen sound considerably. It’s also much heavier, which is why most ceilings are ½-inch thick. There are special use cases where you want to use ⅝-inch thick drywall for ceilings, such as between a garage and living space, and the ceiling above a finished basement.

You can install backsplash on kitchen drywall, as long as you ensure your drywall is clean and dry before you apply the tiles. Your kitchen walls should be made of green board drywall, which is moisture-resistant. If you don’t have green board where your new backsplash will go, you should swap it out.