Get matched with top concrete driveway pros in Mitchell, NE

There’s no legal requirement that states that you need rebar in a concrete driveway, but since the slab will be supporting heavy vehicle loads, it’s always a good idea to pay a bit more for rebar reinforcement. Your driveway will be much more likely to crack if you don’t reinforce it with rebar. Driveways that need to support commercial vehicles or provide parking for multiple vehicles at once should always include rebar reinforcement. If you’re pouring concrete over asphalt or pouring concrete over an existing slab, you may not have enough depth for rebar, meaning an increased risk of cracking.

If your garage floor is heavily soiled or stained, then it’s a good idea to powerwash it with a concrete cleaner before sealing. This process will remove dirt and debris to help the new sealer bond to the concrete properly, and it will also improve the look of your sealed garage floor. After power washing your floor, make sure you let the concrete dry completely before applying sealant, usually for 24 to 48 hours.

For pressure washing a driveway, a PSI (pounds per square inch) between 2,000 and 3,000 is recommended for both concrete and asphalt surfaces. A pressure of 3,000 PSI is ideal for deep cleaning without causing damage, effectively removing debris, dirt stains, and even oil spills. If your pressure washer has a lower PSI rating, you can still use it, but the cleaning process will take longer. For a more efficient and even clean, consider using a surface cleaner attachment.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.