Get matched with top above ground pool installation pros in Gering, NE

An easy way to know whether your sand filter has enough sand is to check how full the filter is and what the sand looks and feels like. The filter container should be two-thirds to three-quarters full of sand. Look for interior marks indicating the ideal sand level. If you put your hand into the sand, it should flow through your fingers without clumping. The filter pressure gauge is also an easy indicator—the right amount of sand leads to normal pressure, while too much or too little sand can cause high or low pressure.

You can spend less time and money on plunge pool maintenance since they are smaller than standard pools. These pools are easier to clean and maintain yourself than a swimming pool. But like any pool, you’ll need to clean the pool walls and floor, balance the chemicals, check the electrical equipment, make necessary repairs, etc.

When you’re winterizing your pool, you need to drain some of the water to prevent cracking and warping from ice. Nonetheless, you should never drain all of the water. Ideally, you’ll lower the water level to anywhere from four to six inches below the skimmer. This will protect the structural integrity of the walls, help prevent your pool liner from warping, and reduce damage from debris.

Pool chemical levels should include a pH between 7.4 and 7.6, alkalinity between 80 to 120 ppm, and chlorine from 1 to 3 ppm. The size and type of your pool determine additional chemical levels, such as stabilizers and pool shock, but you can get to know these numbers using our pool maintenance 101 guide.