Get matched with top masons in Murfreesboro, NC

Brick spalling—which refers to the crumbly, flaky, or pitted appearance that can develop over time—is caused by a few different conditions. These include:

• Climates with constant freeze-thaw cycles

• Use of non-breathable sealants

• High-pressure water cleaning

• Improper installation

While you can’t do anything about the weather, you can preserve your bricks by cleaning them with soapy water and a good old-fashioned scrubbing. Pressure washers may be satisfying to use, but they can eventually wear away the surface of your bricks. If you don’t have advanced-level DIY skills in masonry, you can hire a reputable masonry contractor in your area for your project.

There are many things to look for when buying a brick house. Here are some of the key things you should pay close attention to.

• Lintels: Look for cracks, holes, displacement, or corrosion

• Mortar: Check to see if the mortar is old and crumbling, in need of repointing, or new. Also check to see if the mortar has a professional finish.

• Walls: Check along each side of the house. If a wall is bowing outward, this indicates a severe issue such as foundation damage or that the walls are ready to fall.

• Cracks: If there are stair step cracks in the brickwork, this indicates an unstable foundation.

Yes, bricks can crack over time. While spotting a crack (or several) might be nerve-wracking, cracked bricks aren’t always cause for concern. In fact, it’s normal to see a few small cracks as your foundation settles. However, if the cracks are getting wider or longer or you keep finding new ones, you should have a masonry professional inspect them right away. You should also contact a pro if you notice any large or vertical cracks in your bricks.

Drilling into brick or mortar requires the use of a masonry drill bit. Masonry drill bits appear similar to standard drill bits except for the leading tip of the bit. The tip has a bulky carbide arrow-shaped end slightly larger than the rest of the bit shaft. Standard or high-speed drill bits designed for making holes in wood or metal don’t have the ruggedness or design shape you need to drill into brick. They may not go through the brick at all, and if they do, they’re more likely to overheat, crack, or dull before you finish drilling.