Best deck maintenance specialists near Greensboro, NC

In many areas, a floating deck that isn’t connected to your home and stays under 200 square feet and below 30 inches in height may not need a permit. These freestanding structures are often considered low-risk, which can simplify the building process. However, building codes vary greatly based on location. Before investing in any home improvement project, check with your local permitting office for deck-building guidelines.

Most building codes require that spindles or balusters on deck and stair railings be spaced no more than four inches apart. This safety standard, often called the '4-inch sphere rule,' is designed to prevent small children or pets from slipping through the railing. A good way to visualize this is that a 4-inch sphere should not be able to pass between two spindles. For the same safety reason, the space between the bottom rail and the deck floor should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is crucial to check your local building codes to ensure compliance before starting your project.

As with patios, there are many types of deck choices to choose from to add personalization to your home. Some common deck options include:

• Attached decks are anchored to the home and include simple ground-level options or multi-level structures with stairways and separate landings. 

• Detached island decks are not attached to the home; they’re a freestanding structure in the yard. 

• Wraparound decks connect the back of the house with at least one other side and often are built with railings for safety. 

• Multi-level decks connect your deck through varying levels of elevation, featuring landings that are attached to stairs.

Applying too much sealer to a deck might seem like extra protection, but it can cause more harm than good. Wood is a porous material with a limited capacity to absorb liquids. When you go overboard with sealer, the excess can't soak in and instead forms a film on the surface. This leftover layer is prone to peeling, cracking, and trapping moisture, ultimately defeating the purpose of sealing in the first place.