Top-rated toilet pros.

Get matched with top toilet pros in Ferguson, NC

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Ferguson, NC?

Select your specific project to find the pro for you.

TRUSTED BY FERGUSON, NC HOMEOWNERS

  • Average homeowner rating star icon4.5
    Average homeowner rating
  • Verified reviews icon217
    Verified toilet services reviews

Find Toilet pros in Ferguson

Avatar for The Plumbing Firm, LLC
The Plumbing Firm, LLC
5.0(
15
)

Serving Ferguson, NC and surrounding areas

In business since 2021

Free estimates

Emergency services offered

"Iâ ve had this company install two toilets, snake a drain, and fix two leaky pipes. Very Courteous, reasonably priced, cleaned up after he was done, Would highly recommend!"
Response time6 hrs
Response rate85%
Recommended by83%of homeowners
Avatar for Arrow Plumbing and Pipe works
Arrow Plumbing and Pipe works
4.3(
38
)

Serving Ferguson, NC and surrounding areas

In business since 2015

Free estimates

Credit card accepted

"Jeff was honest and upfront about costs and supply issue. When the pump for well finally arrived Jeff worked hard to get me back to normal. When another issue arose he was able to get the supplies needed quickly to get the work done. I highly recommend this pro"
Response time1 day
Recommended by93%of homeowners
Showing 1-10 of 45
Toilets questions, answered by experts

If your toilet is still leaking after replacing the toilet flapper, then you may not have installed the toilet flapper correctly. Double-check that you have placed the flapper over the overflow tube correctly, and check the flapper chain is at the right length. If your toilet is still leaking, then you may have another problem on hand. For example, you may need to replace the toilet wax ring or replace the toilet fill valve if your toilet is wobbly and leaking from around the base.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

The normal water level in a toilet bowl is about halfway full. The water should sit above the P trap drain because this creates a seal and suction. When you flush the toilet, the suction keeps sewer gases from entering your house through your toilet. Anytime the water level is higher or lower than half full, you need to make adjustments or replace broken parts.

To avoid the high costs of plumbing repairs, watch for potential problems. If you see any signs of a leak, consider hiring a professional plumber. A pro can assess the level of damage and make the appropriate repairs.

Plumbing leaks are always better tackled immediately. You can also fix any minor repairs yourself or ask the plumber if they can use less expensive materials.

The Ferguson, NC homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.