Best pressure washers near Cherry Point, NC

It depends on the type of surface, but if you’re preparing to pressure wash a driveway, you’ll start by using a broom or leaf blower to get rid of dirt, leaves, and other debris. Then, move any nearby items (like outdoor furniture and potted plants) and cover in-ground plants with a tarp or plastic sheet. After that, you can apply degreaser spray or another pretreatment solution to any stains and scrub them with a stiff brush before pressure washing.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.

Not pressure washing your driveway can lead to several consequences that affect both its appearance and its structural integrity over time:  

• Reduced Curb Appeal: A dirty driveway covered in grime, stains, and mildew detracts from your home's overall appearance.  

• Safety Hazards: The buildup of algae, moss, and mildew creates slippery surfaces. When wet, it increases the risk of slips and falls for you, your family, and visitors.  

• Structural Damage: Dirt, debris, and organic growth can trap moisture against the driveway's surface. In colder climates, this moisture can freeze and thaw, leading to cracks and deterioration of the concrete or asphalt.

While power washing isn't a requirement before you stain a fence, it can make the job much easier and faster while reducing manual labor requirements. The stain will not work if the wood is full of dirt and dust, so power washing, sometimes called pressure washing, is a fast and effective way to prepare the wood for staining. Remember that you need to stain or repaint relatively soon after the wood has dried so that there isn’t time for dust and dirt to build up again.