Get matched with top fencing pros in Sweet Grass County, MT

In most cases, you will need a building permit to put up a vinyl fence, especially if the fence is sitting on or close to your property line. You can ask your local building department or  fence installation company if your fence project will require a permit. If so, you can expect it to cost between $20 and $60. Your fence installer should pull the permit for you. Building without a permit could eventually require you to pay again to remove the fence and reinstall it after getting the job approved.

Green branches are more flexible and easier to work with, but they'll shrink as they dry, which can loosen your fence weave over time—so you'll need to weave them extra tight to account for shrinkage. Some species, particularly willow, may also try to sprout when used green. For these reasons, it’s typically easiest to use branches that have dried for a week or two.

You can DIY a stockade fence installation, but prepare to put in some good sweat equity. For the best results, carefully plan the exact location of your fence before you break ground. In particular, carefully map out your post locations before setting them in concrete. Be sure to call your local utility company before digging to avoid damaging underground wiring and causing severe injury.

On the other hand, installing stockade fencing on your own might sound too overwhelming. It’s certainly time-consuming and labor-intensive. Besides the hard work, you must install it properly to avoid gaps. Unless you’re confident you can get the job done right, hiring a privacy fence installer near you is the way to go.

Issues include rust, loose posts, and damaged mesh. Regular maintenance prevents significant problems.