Get matched with top water softener pros in Sidney, MT

The average cost to install a water softener, including the system and labor, is approximately $1,500. However, the total price can range widely from $600 to $6,000. For some complete systems, the cost may be between $800 and $2,500. Labor for the installation typically costs between $150 and $1,000.

The final price is influenced by several factors, including:

• System type, capacity, and complexity

• Home size and household water demands

• Water hardness levels

• Accessibility of the installation site and the extent of plumbing work required

• Whether new electrical work is needed

• The professional hired and any local permit costs

Some shower water softeners are effective, but this isn’t always the case. Most shower filters only filter out chlorine, not hard minerals like calcium. Other shower filters can't handle the demand in homes with very hard water. It's also important to change the filters on your shower filters. Failure to regularly swap out old filters will make the filter ineffective over time. 

Whether you need a permit or license for a water softener installation depends on your location, as requirements vary significantly. Some municipalities require the installer to hold a plumbing license, some mandate a permit and an inspection, and others require both. In some areas, no special permit or license is needed at all.

To determine the rules in your area, you can contact your local building department or consult a local water softener installer or plumber. Often, only certified professionals are authorized to pull the necessary permits, and they will typically handle the entire permitting process for you. Regardless of local laws, it is always recommended to hire a licensed professional to ensure the system is sized and installed correctly. You can use Angi’s state licensing tool to check an installer’s license status.

The most accurate way to determine whether you have hard water is to purchase a water test kit from a hardware store or send a tap water sample to a lab. But there are some signs you can look out for without professional testing. For instance, if you're consistently dealing with mineral stains on your glassware, windows, and shower doors, you're likely to have hard water. Hard water can also make it harder to lather and rinse soap, so if you're struggling to work up a good lather in the shower, hard water might be the culprit.