Get matched with top sink installation pros in Saint Ignatius, MT

Yes, you can remove an undermount sink from granite countertops. However, it’s safest to hire a granite pro to take on this job. Your pro might have to make cuts and grind the granite to remove the sink. Plus, if you’re replacing your sink with a larger one, you’ll need your pro to enlarge the existing sink cutout in your granite.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Older faucet fixtures may have some corrosion, leaving them stuck. Try a few techniques to loosen the fixtures.

• Wrap the fixture with a towel and tap the base with a hammer.

• Use a putty knife to gently remove any caulk that may be holding the handle or fixture in place.

• Apply a few drops of penetrating oil around the base of the fixture or around the nuts.

• Purchase a faucet pulling tool to pop the fixture loose.