Get matched with top sink installation pros in Helena, MT

Try to tighten the clevis crew and adjust the lift rod if your sink stopper won’t stay up. Sometimes your screws became too loose over time, and as a result, there wasn’t enough resistance to keep the sink stopper up. If a damaged lift rod is the cause of the problem, you will need to replace it with a new rod.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

A good option for opening up and cleaning a sink drain is to use a ¼ cup of baking soda and 1 cup of white vinegar, along with a rubber stopper to cover the drain while those materials work their magic. After about 15 minutes, you can flush the drain with hot water. In many cases, these materials can scrub out minor clogs and get the drain working properly again. If the issue persists, call in a plumber near you to get the problem permanently fixed.