Best sink installation pros near Great Falls, MT

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

Putting in a new bidet attachment or seat requires as little as 30 minutes. Installing a full bidet toilet or stand-alone bidet might take one to three hours. Additionally, if you need a GFCI outlet installed, that can take 30 minutes to three hours depending on the complexity of the job.

According to the U.S. Environmental Protection Agency (EPA), a leaky faucet that’s dripping at a rate of one drip per second can waste more than 3,000 gallons of water per year. This is one reason why it’s important to fix a leaky faucet sooner rather than later.

Today’s standard sink stopper size is 1.5 inches. However, you can still find different sizes if your house uses an older sink stopper. Other sizes you can find in most hardware stores include one inch, 1-1/4 inch, 1-3/8 inch, 1-5/8 inch, 1-7/8 inch, 2 inch, 2-1/4 inch, 2-3/8 inch, and 2.5 inch.