Get matched with top concrete driveway pros in Tupelo, MS

You should avoid using a pressure washer on any surface or item that could be damaged by the high-pressure spray, as some materials are too delicate to withstand the force.

Key items and surfaces to avoid include:

• Electrical Components: Never pressure wash electrical systems, as water can cause short-circuits and create a safety hazard. This includes utility meters, breaker boxes, electrical outlets, generators, and HVAC or air conditioner units.

• Delicate and Fragile Materials: Fragile items can crack, shatter, or be stripped by the pressure. Avoid pressure washing windows, glass, light fixtures, shingled roofs (especially asphalt), and stucco.

• Painted, Stained, or Sealed Surfaces: Unless your goal is to strip the finish, do not pressure wash painted surfaces, stained wood (like decks), or anything with a protective seal that could be stripped away. Be especially cautious with older surfaces that may contain lead paint.

• Soft Woods and Certain Decking: Delicate surfaces like softwood, composite decking, and antique or wooden patio furniture can be etched or damaged. If you must wash wood, use a lower-powered pressure washer with a wide-angle nozzle to prevent damage.

• Living Things: Never use a pressure washer on people, pets, or plants. The force can cause serious injury and will destroy landscaping.

The time it takes to pressure wash your driveway is mainly based on size (but your driveway’s material and condition also play a role). Small driveways can be pressure washed within an hour, medium within two hours, and large within four hours. However, this does not consider any prep time or time that sealing your driveway would take.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

It is generally not recommended to use dish soap in a pressure washer. Dishwashing liquid is formulated for cooler water, and the warmer water used in a pressure washer can create excessive suds, potentially damaging the machine's tubing and other components. Always check the manufacturer’s instructions for recommended detergents. If you find yourself in a pinch, you can try a highly diluted solution, such as one tablespoon of dish soap per 1.5 quarts of water, to avoid clogging the machine.