Get matched with top electricians in Tunica, MS

You should never wire neutral and ground wires together at a light switch. Not only is it unsafe, but it’s also incorrect. The neutral and ground wires perform separate functions in an electrical circuit and should never be swapped or wired together at a light switch, light, or outlet. 

Smart light switches are designed to be compatible with most lights and traditional home wiring, but there are several key factors to check. First, verify your home's wiring, as some smart switches require a neutral wire to operate, which may not be present in older houses (often built before 1985). Always check the wiring requirements for the specific model you choose. Second, consider your light bulbs; while smart switches work with almost any light, using a dimming feature requires dimmable bulbs, such as dimmable LEDs. Finally, ensure you have the necessary network connection. Most smart switches need a Wi-Fi connection for remote control, but some older models might use other standards like ZigBee, which would require a compatible hub.

You can make a pigtail with either thermoplastic high-heat-resistant nylon-coated (THHN) wire or non-metallic (NM) cable, often referred to as “Romex.” Each pigtail requires a neutral wire, a ground wire, and a live wire. The gauge of your pigtail wires must match the gauge of those on the device. 

To fix a tripped light switch, locate your home's electrical panel and identify the tripped circuit breaker. It will be in the "off" or neutral position. Flip the breaker entirely to the "off" position, then switch it back to the "on" position. If the breaker trips again immediately, there may be a short circuit or overload in the system, requiring further investigation. If the switch still doesn't work after resetting the breaker, check for loose wires or faulty components in the switch itself. It is always best to consult a licensed electrician for persistent issues and when in doubt.