Get matched with top fence painters in Tchula, MS

The general consensus is that two coats of stain are required and since the cedar is siding, a third coat of sealant is always a good idea. This helps protect the wood and stain, so you won’t need to resand and restain for at least a decade. Each stain after the first will darken the wood, so be aware of that when choosing a colored stain.

Rags used with oil-based stains are highly flammable and can spontaneously combust in the right conditions. To reduce the fire risk, throw them in a metal container after use and add rocks on top to secure them. Add an inch of water and seal the container. Take the rags in the container to a hazardous waste factory as soon as possible.

You can paint an old wooden fence, but make sure first to do a deep clean (ideally with a pressure washer) and inspect the fence for any existing damage. Painting over dirt and debris will cause your paint to peel. Once you’ve cleaned and repaired any minor issues, use a primer and high-quality satin paint.

You shouldn't paint a metal fence. Painting doesn't necessarily damage a corrugated metal fence, but these types of fences are meant to flex, and paint can easily chip and break off. Latex paints can address this issue, but those tend not to be very weather-resistant. Certain paints can trap moisture in the corrugation, which can rust the metal and lead to corrosion. And finally, if you paint a copper fence, it won't patina, which is one of the main reasons people buy copper.