Get matched with top pressure washers in Sledge, MS

Whether you need to winterize your pressure washer depends on where it will be stored. If it's kept in a location where temperatures could drop to freezing, any liquid left in the water pump can freeze, expand, and cause severe damage to the machine. To prevent this, you can add antifreeze to the pump. While emptying the machine with compressed air is an alternative, it can be a tedious process and may not remove all the liquid. If you can store the pressure washer in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, regardless of storage conditions, it is good practice to empty the gas chamber and refresh the oil before storing it for the winter.

It’s important to avoid power washing your house during freezing temperatures because the excess water can freeze on surfaces and cause damage. You should also avoid doing this task during heavy wind or rain because the water spray becomes less effective and could spread debris. Don’t power wash your home if your siding is cracked, loose, or peeling because the high pressure can worsen the damage. Lastly, if your home has delicate materials like softwood or stucco, consider gentler cleaning methods to prevent structural harm.

You should never use bleach in a pressure washer. While bleach is effective at killing mold and mildew, it is a potent chemical that can corrode the machine's seals and nozzles, destroying it from the inside out. Additionally, pressure washing with bleach sprays the chemical into the air, which is dangerous if inhaled and can kill nearby plants, flowers, or harm animals that ingest it. If you need to remove mold or mildew, it is best to hire a professional who will use a safe and effective cleaning agent.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.