Top-rated pressure washers.

Best pressure washers near Drew, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your pressure washing project in Drew, MS?

Select your specific project to find the pro for you.

Top-Rated Pressure washers in Drew - Updated Nov 2026

Jared
New to Angi
Exterior Surfaces - Powerwashing

Serving Drew, MS and surrounding areas

Approved

My name is Jared and I enjoy what I do for a living. I offer professional and quality services in home remodeling and I take my time and do everything the customer asks. I have been doing construction since I was a young man at the age of 16 and I'm 47 year's old now,In. 2026.. If you have any questions about anything else please contact me and I'll try my best to answer any questions you have about any project.Also thank-you for reading and have a wonderful day.

...
Showing 1-10 of 78
Pressure Washing FAQs, answered by experts

For pressure washing a driveway, a PSI (pounds per square inch) between 2,000 and 3,000 is recommended for both concrete and asphalt surfaces. A pressure of 3,000 PSI is ideal for deep cleaning without causing damage, effectively removing debris, dirt stains, and even oil spills. If your pressure washer has a lower PSI rating, you can still use it, but the cleaning process will take longer. For a more efficient and even clean, consider using a surface cleaner attachment.

You should always power wash your driveway before applying a sealant. At any given time, your driveway could be covered with algae and moss, tire residue, oil and rust stains, and any combination of leaves, twigs, and dirt. If you skip power washing, you’ll be trapping the dirt and grime beneath the sealant and lowering its chance of cementing itself to your driveway. While you can expect the cost to pressure wash your driveway to average between $100 and $350, the few hundred dollars beats an unattractive driveway or paying extra to reapply your driveway sealer.

Not pressure washing your driveway can lead to several consequences that affect both its appearance and its structural integrity over time:  

  • Reduced Curb Appeal: A dirty driveway covered in grime, stains, and mildew detracts from your home's overall appearance.  

  • Safety Hazards: The buildup of algae, moss, and mildew creates slippery surfaces. When wet, it increases the risk of slips and falls for you, your family, and visitors.  

  • Structural Damage: Dirt, debris, and organic growth can trap moisture against the driveway's surface. In colder climates, this moisture can freeze and thaw, leading to cracks and deterioration of the concrete or asphalt.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

You should always hook up your pressure washer to the water supply before turning it on and ensure there’s a good water flow. If you try to turn the machine on without water in the system, it overworks and overheats the unlubricated pump. This can quickly lead to irreversible damage.

The Drew, MS homeowners’ guide to pressure washing services

From average costs to expert advice, get all the answers you need to get your job done.