Get matched with top sump pump installation pros in Raymond, MS

If your sump pump isn’t engaging, it might be clogged with dirt and debris. Check to see if the fitting lid is loose and has been letting debris in. Next, check the float and make sure it’s not obstructed by rust or gunk, which results from insufficient maintenance. Tangled wires or damaged switching systems can also stop your sump pump from engaging.

A sump pump's lifespan is typically 7 to 10 years, though the general range can be anywhere from 5 to 15 years. The specific type of pump is a major factor: pedestal sump pumps last an average of 20 to 25 years, whereas submersible sump pumps last between 5 and 15 years. While pedestal pumps are less expensive to service, they are also louder and more prone to clogging.

Several other factors influence longevity, including the pump's quality, usage frequency, and maintenance schedule. A high-quality pump that is well-maintained in a dry climate may last for two decades, while a lower-quality, poorly maintained pump in an area with a high water table or frequent flooding may fail in six years or less.

Regular maintenance, including annual inspections and tuneups from a professional, can significantly extend the pump's life. It is time to consider a replacement if your sump pump runs constantly, cycles frequently, shows visible rust or corrosion, or trips a circuit breaker. As a preventative measure, many homeowners replace their pumps every eight years. It's also worth noting that a manufacturer's warranty can indicate expected lifespan, and some home insurance policies may not cover water damage from a pump that is past its recommended replacement date.

The most common cause of a clogged sump pump is natural debris buildup. As water enters the sump pit, it can carry small pieces of debris that build up over time, or the debris can get caught in the filter. If you forget to cover the pit after cleaning the sump pump and pit, debris can also collect in the pit. Corrosion on the metal discharge pipe can also clog the pump. Additionally, if your pipes freeze, it can prevent water from draining properly and cause a clog.

A sump pump can be plugged into a regular, 110-volt outlet with three-prong openings, but it must have GFCI protections per the NEC, meaning you’ll need a GFCI outlet and circuit. Sump pumps require two outlet openings, one for the plug to the motor and one for the float switch.