Top-rated ceiling fan pros.

Get matched with top ceiling fan pros in Pearl, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your ceiling fan service project in Pearl, MS?

Select your specific project to find the pro for you.

Find Ceiling fan pros in Pearl

Avatar for LMD Construction LLC
LMD Construction LLC
4.7(
3
)
Ceiling Fan - Install

Serving Pearl, MS and surrounding areas

Approved

In business since 2023

Free estimates

Credit card accepted

"Luis and his team did a great job on my commercial renovation project. They delivered the project on time and on budget. I’d definitely hire LMD Construction again."
Response time12 hrs
Response rate97%
4 neighbors recently requested a quote
Avatar for Darling Electric, LLC
Darling Electric, LLC
4.9(
49
)
Ceiling Fan - Install

Serving Pearl, MS and surrounding areas

In business since 2017

Free estimates

Warranties offered

"He put in two bathroom vent fans after we had the ceiling repaired from steam damage. He was neat and we appreciated his expertise. Also upgraded wiring in shed and added a plug in. He responded quickly to our request and showed up when we expected him to. Will hire him again."
Response time1 day
Recommended by89%of homeowners
...
Showing 1-10 of 99
Ceiling Fans questions, answered by experts

Fans not turning on, wobbling, noisy motors, or faulty remote controls are common issues requiring repair.

Many ceiling fan mounts feature a design that can accommodate slight slopes by using a ball joint mechanism at the end of the downrod. If your ceiling has a steeper slope than your fan allows for, you can install a downrod that will allow your fan to safely hang below the slope.

The most efficient ceiling fan height is 8 to 9 feet from the floor to the fan blades. For ceilings higher than 9 feet, a downrod can be used to lower the fan to the optimal height. This positioning ensures adequate air circulation and maximizes the cooling effect. Remember, fans should be installed at least 7 feet above the floor for safety.

If you’re removing a ceiling fan without visible screws, start by locating the fan canopy—a round cover placed above the fan blades and motor. There should be a thin ring that can be turned counterclockwise to remove the canopy and reveal the screws. After unscrewing the fan, you can disconnect the wires and remove the entire fan from the mounting hardware. For safety, make sure the fan switch is turned off before you remove the canopy. It may be easier to remove the fan blades first, too.

To determine if your ceiling box can support a fan, you must check if it is specifically fan-rated. Manufacturers are required to indicate this on the box itself. You may need to remove the existing light fixture to look inside the ceiling box for an inscription stating it is rated for fan use. If you do not see this confirmation, the box is likely not strong enough and must be replaced with a fan-rated junction box. For a proper and safe installation, you should also use a fan brace to secure the new box between the ceiling joists, which provides the necessary support for the fan's weight and motion.

The Pearl, MS homeowners’ guide to ceiling fan services

From average costs to expert advice, get all the answers you need to get your job done.