Get matched with top concrete driveway pros in Madison, MS

You should never use bleach in a pressure washer. While bleach is effective at killing mold and mildew, it is a potent chemical that can corrode the machine's seals and nozzles, destroying it from the inside out. Additionally, pressure washing with bleach sprays the chemical into the air, which is dangerous if inhaled and can kill nearby plants, flowers, or harm animals that ingest it. If you need to remove mold or mildew, it is best to hire a professional who will use a safe and effective cleaning agent.

For pressure washing a driveway, a PSI (pounds per square inch) between 2,000 and 3,000 is recommended for both concrete and asphalt surfaces. A pressure of 3,000 PSI is ideal for deep cleaning without causing damage, effectively removing debris, dirt stains, and even oil spills. If your pressure washer has a lower PSI rating, you can still use it, but the cleaning process will take longer. For a more efficient and even clean, consider using a surface cleaner attachment.

The ideal frequency for pressure washing depends on the surface being cleaned and your local environmental conditions. For a home's exterior with siding that is safe to wash (such as vinyl, cement, or aluminum), a full wash once or twice a year is a good guideline to remove accumulated dirt, grime, mold, and mildew. You may need to wash more frequently if you live in an area with heavy rain or snow, near a dirt road, or if you notice excessive buildup. Other surfaces have different schedules; for example, a frequently used driveway may need cleaning more often, while outdoor patio furniture might only need to be washed every few years. Use your discretion based on how dirty the area gets.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.