Get matched with top water heater pros in Laurel, MS

While a water heater explosion is rare, it is a serious danger. Be aware of these critical warning signs:

• Sulfur or Rotten Egg Smell: This is a major red flag, especially for gas water heaters. It can indicate a gas leak, which could ignite and cause an explosion.

• Leaking Pressure Valve: If the temperature and pressure (T&P) relief valve is leaking, it may not be able to properly regulate internal pressure, creating a risk of bursting.

• Shaking or Rumbling: Loud rumbling or shaking from the tank can be a sign of extreme pressure buildup.

• Excessive Heat: If the exterior of the water heater feels unusually hot to the touch, the unit may be overheating dangerously.

• Rust-Colored Water: This can be a symptom of severe internal corrosion that compromises the tank's integrity.

If you notice any of these signs, especially a gas smell, you must act immediately. Shut off the gas supply to the water heater and call a professional plumber right away to prevent a potential disaster.

In most municipalities, a license is not mandatory for water heater installation or replacement. However, we strongly recommend hiring a licensed plumber or water heater installer to handle the work. Licensed installers are far less likely to make a mistake during the installation, which means paying for the experience decreases your risk of a leak and other issues. You can use our state licensing tool to find out if a contractor you’re considering in your area holds a plumber’s license.

The average cost to replace a water heater is around $1,325, with a typical range of $900 to $1,800 for a standard replacement. The final price depends on the type of heater (tank vs. tankless), its size, fuel source (gas or electric), and the complexity of the installation. A simple one-to-one replacement will be on the lower end of the cost spectrum. However, if you are switching from one type of heater or energy source to another, you can expect labor costs to be significantly higher due to the extra work involved. It's also worth considering that while gas and electric heaters may have similar upfront costs, their long-term operating costs can differ based on local utility prices.

Due to the high temperature, using stainless steel vent pipes for your tankless water heater’s exhaust vent is best. Also, it is safe to use a flexible vent duct as the exhaust fan. If installing the exhaust fan yourself, make sure you are using heat-resistant silicon to connect the exhaust vent and the duct on your water heater.