Top-rated insulation pros.

Best insulation pros near Lambert, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your insulation service project in Lambert, MS?

Select your specific project to find the pro for you.

Top-Rated Insulation pros in Lambert - Updated Nov 2026

Avatar for Queen City Insulation Co Inc
Queen City Insulation Co Inc
5.0(
4
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeInjection Insulation - Install+2 more

Serving Lambert, MS and surrounding areas

"The receptionist took the call and told me to expect a all from the technician. He called back immediately to set up an appointment. Greg was quick and professional. I plan to hire them again if I need anything. I went into their office to pay the bill and the receptionist was very helpful and pleasant."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+3

Recommended by100%of homeowners
Avatar for ADT Solar
ADT Solar
4.4(
111
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeInjection Insulation - Install+2 more

Serving Lambert, MS and surrounding areas

In business since 2008

Free estimates

Warranties offered

"Rep. checked entire system. He found several wires not connected properly and fixed this. He also made recommendations regarding the attachment of the panels to the rood that would provide more stability and leakproofing. The representative appeared to know what he was doing - much better than others, including the representative who was engaged by the roofer (who replaced our rood due to hail damage) to disconnect/connect the panels."
11 kW PV Installation
5 kW PV Installation
9.5 kW PV Installation
Recommended by89%of homeowners
Showing 1-10 of 20
Insulation FAQs, answered by experts

When it comes to fiberglass insulation versus foam board, there are a few notable differences, both aesthetically and functionally. Fiberglass insulation is soft and flexible, meaning it can be squeezed into tight spaces more easily than foam board. Fiberglass insulation also has a higher R-value, making it a better pick for colder climates. However, foam board insulation can resist moisture and pest damage much better than fiberglass.

An outdoor spigot needs some attention before the temperatures begin to drop. Using an insulative cover is just one part of minimizing a frozen spigot and pipes. You’ll also need to shut off the water and drain the spigot, which leaves as little water as possible in the pipes to prevent freezing.

The most energy-efficient windows are double—or triple-pane windows with low-emissivity (Low-E) coatings and gas fills between the panes. These windows reduce heat transfer, prevent drafts, and help maintain a consistent indoor temperature. But if replacing windows isn’t in your budget, pairing your existing windows with insulating window treatments can still make a noticeable difference in home comfort and monthly bills. 

Your house may be cold even if the heat is on because of bad insulation, gaps in doors, small holes pulling hot air from the home, or excess humidity. The heater itself might be malfunctioning. For this problem, you’d need to talk to an HVAC pro. If you have a gas heating system (most do) this should be considered an urgent job as natural gas could be leaking in your home.

A-frame houses pose specific challenges that can make heating difficult. Their open concept design with high ceilings can lead to a colder lower floor and a warmer upper floor. A ceiling fan that pushes warm air down or pulls cold air up, depending on the season, can easily counteract temperature issues. Additionally, certain types of heating do better in these homes than others. For example, heated floors tend to be more practical and energy efficient than baseboard heating.

The Lambert, MS homeowners’ guide to insulation services

From average costs to expert advice, get all the answers you need to get your job done.