Get matched with top sink repair pros in Freeman, MO

Yes, you can fit a vanity unit to an existing sink, especially if you plan to custom-build the vanity. With a prefabricated vanity, you’ll likely need to make a few adjustments. It depends on the type of sink, the size of the sink, and the existing plumbing. If you plan to retrofit a sink into a prefabricated vanity, make sure you take precise measurements and that your sink is compatible with the vanity you select. Prefabricated units have a precut sink hole, so you’ll need the size to match your sink.

Try to tighten the clevis crew and adjust the lift rod if your sink stopper won’t stay up. Sometimes your screws became too loose over time, and as a result, there wasn’t enough resistance to keep the sink stopper up. If a damaged lift rod is the cause of the problem, you will need to replace it with a new rod.

There are several types of sink drain stoppers, including pull-out, twist-and-pull, and pop-up. Pull-out sink stoppers can be removed by pulling on the stopper until it comes out of the drain. A twist-and-pull design requires lifting then turning the stopper to lock it in an open position and the opposite action (turning, then pressing down) to close it. A pop-up sink stopper works by pushing down the drain cover to open or close the passageway. 

While unplugging your garbage disposal and plugging it back in may help, most units have an actual reset button, a bright red switch found on the underside of your unit. If your garbage disposal needs resetting, you may notice this button sticking out about a quarter of an inch from the surface of the unit, with which it’s usually flush. Simply depress this reset button to reset the unit, and then test to ensure it’s working about 10 minutes later.