Get matched with top water heater pros in Tower, MN

Any item that can hold on to moisture and encourage mold growth should be discarded and replaced following water damage. Upholstered items, such as armchairs and couches, and soft items, such as mattresses, usually must be thrown away once they've taken on a lot of water. Soft furniture is difficult to dry out, creating an inviting environment for mold.

You may also need to replace hardwood furniture following water damage if you're unable to fully dry it out. If you have appliances and electronics that have been fully submerged in water, particularly sewage, you'll need to replace those, too.

Several signs indicate your water heater may be failing or in need of replacement. Key indicators include:

• Age: A water heater older than ten years is approaching the end of its typical lifespan.

• Water Quality: If you notice rusty or discolored water from your hot water faucets, or a foul odor similar to rotten eggs or sulfur, it can signal internal corrosion.

• Unusual Noises: Banging, rumbling, or popping sounds from the tank often mean sediment has built up, causing the unit to overheat.

• Leaks: Any water pooling around the base of the tank or visible leaks are clear signs of failure.

• Performance Issues: A decline in performance, such as water not getting hot enough, taking longer to heat up, low water pressure, or decreased efficiency, suggests the unit is struggling.

• Visible Damage: Obvious rust and corrosion on the exterior of the tank can indicate a more serious internal problem.

While these signs often point to replacement, some issues may be fixable. It's best to consult a professional plumber to diagnose the problem before investing in a new unit.

In most municipalities, a license is not mandatory for water heater installation or replacement. However, we strongly recommend hiring a licensed plumber or water heater installer to handle the work. Licensed installers are far less likely to make a mistake during the installation, which means paying for the experience decreases your risk of a leak and other issues. You can use our state licensing tool to find out if a contractor you’re considering in your area holds a plumber’s license.

No. Expansion tanks must be installed on the supply side (where heated water flows out) of the boiler. There’s also a list of other requirements for most boilers, including being above the pressure relief valves, being on the inner side of any circulator, and more. Your installation manual should have more information on expansion tank installation requirements and what sort of tank the system is made for.