Top-rated septic tank pros.

Get matched with top septic tank pros in Tower, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your septic tank service project in Tower, MN?

Select your specific project to find the pro for you.

Find Septic tank pros in Tower

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Septic System - Install or ReplaceSeptic System - Install or Replace - For BusinessSeptic System - Repair+3 more

Serving Tower, MN and surrounding areas

In business since 1971

Credit card accepted

"The technician emptied the freezer, which was in the basement, to work on the part that needed repair. Then he neglected to put anything back into the freezer, including a turkey I had bought for Christmas and a rack of ribs. Two days after he left, I went out of town for two weeks. The turkey actually exploded and spewed its liquid all over everything, which had to be discarded. I let AHS know and they couldn't even bother to call me or follow up on this. I'm considering not renewing my contract with them because of the quality (or lack thereof) of many of the providers they send."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Septic Tanks questions, answered by experts

A septic alarm can sound different depending on your system, but often, it’s a loud, repetitive beeping noise or a steady, high-pitched noise. It may also be a loud buzzing noise. To confirm the noise is your septic alarm, check your alarm box for a red light. You can also silence your alarm with a red button or switch on the box. Look for something that says “Test” or “Mute.”

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

  • If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

  • If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.

Although air in your water lines won’t affect the overall quality of your water, it will lead to problems with your well water system if not addressed. Over time, too much air in your water lines can create blockages in your pipes, cause insufficient water flow to your taps and appliances, loosen pipes, and potentially damage important components of your well including your well pump and pressure tank. 

If your well pump is running continuously (meaning without turning off or stopping), it's a sign that your well pump is starting to break down. The length of time your well pump should cycle is dependent on many factors, like the tank size, pressure setting, and even the amount of water in your well. Generally, your well pump should cycle, or go from running to not running every few minutes.

You should never park or drive on top of a septic field. Vehicles can weigh upwards of two tons, and this weight can put a lot of pressure on the leach lines in the drain field. Too much pressure on your leach lines may cause them to warp, crack, or completely burst. This is an expensive and very avoidable problem.

The Tower, MN homeowners’ guide to septic tank services

From average costs to expert advice, get all the answers you need to get your job done.