Get matched with top water heater pros in Orr, MN

The lifespan of a water heater depends on its type, usage, and maintenance schedule. Traditional tank-style water heaters typically last between 8 and 12 years, though the range can be as wide as 6 to 15 years. Within this category, gas models often last 8-12 years, while electric models may last 10-15 years. In contrast, tankless water heaters have a significantly longer lifespan, often lasting up to 20 years or more. Factors like heavy usage, hard water, and sediment buildup can shorten a unit's life. To extend its lifespan, it is crucial to perform regular maintenance, such as flushing the tank annually and scheduling professional inspections. If your unit is over a decade old and shows signs of rust, leaks, strange noises, or inconsistent heating, it is likely time for a replacement.

No state requires you to vent an electric water heater. Other installation requirements for water heaters will vary, though, depending on the state and local jurisdiction in which you live. Some places require permits, while others don’t. Some may force you to place the appliance a certain distance from any walls or other appliances, while others don't. When you find a local professional to install a water heater, this expert will ensure you follow all the local regulations.

No, you’ll need to drain the tank before changing a water heater element, as the water heater element sticks through the side of the tank and uses a gasket to prevent water from pouring out. However, you don’t always need to drain it completely. If you’re only replacing the upper heating element, you can drain the tank until the water line is below the element. If you’re replacing the lower element, you’ll need to drain the whole thing.

The standard copper wire gauge to use with any 30-amp circuit is a 10-gauge wire. The National Electric Code specifies a 10-gauge wire with appliances like water heaters running on 30 amps. If you try to use a smaller gauge wire, such as a 12 gauge, with a 30-amp breaker, you run the risk of the wire overheating and melting or causing a fire. Because of the safety hazards, the gauge of the wire is not an area to try to cut costs when connecting a 30-amp breaker to a water heater.