Top-rated drywall pros.

Get matched with top drywall pros in Pierz, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Pierz, MN?

Select your specific project to find the pro for you.

Find Drywall pros in Pierz

Avatar for Northern Lakes Drywall
Northern Lakes Drywall
5.0(
7
)

Serving Pierz, MN and surrounding areas

Free estimates

Warranties offered

Credit card accepted

"Jeremy gave us a quote on all repairs for the work that had to be done reasonably estimate and also some extras … the crew was on time and did a exceptionally great job on all was done in the time they had said !! The job was done great from start to finish !!! I would recommend Jeremy and Northern Lakes Drywall to all !!!!! If your looking for a professional job and a reasonable price this is your place !!!! Thanks again!!!"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+7

Recommended by100%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)

Serving Pierz, MN and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Mike Peka Drywall
New to Angi

Serving Pierz, MN and surrounding areas

In business since 1986

Free estimates

Small jobs welcome

Mike Peka Drywall is your premium drywall installation, repair, and finishing company. With over 26 years of industry experience we have done it all, seen it all, and there is nothing we have not done before so you know it will be done right. We are reliable and responsible and since we are own run and operated the owner is on every project.\n\nGive us a call today for a free estimate!

Showing 1-10 of 27
Drywall questions, answered by experts

The short answer is yes, a sagging plaster ceiling is dangerous. Sagging plaster on a wall is something you should fix immediately, but it isn’t a major concern. If the same type of sagging occurs on a ceiling, however, you could be in danger of your ceiling falling in large chunks. When plaster sags, it loses its strength and ability to hold itself up. The bonds that hold it together are strong, though, so if a sagging area falls, it will take large pieces down with it.

Metal corners, often referred to as corner beads for square corners, are used on drywall installations to provide structural reinforcement to vulnerable outside corners. Their usage safeguards against chipping, denting, or other forms of damage, enhancing the overall durability of the wall. Metal corners also offer a precise and straight edge that facilitates sharp and clean lines, crucial for achieving a polished and professional finish.

You should stagger drywall sheets to help prevent cracking. The joints between drywall sheets are the weak spots, so if you install drywall with seams aligned, you’ll create weak lines that run across the length of the wall and extend from floor to ceiling. But when you stagger drywall, the solid sections of panels will support the joints. This can prevent seams from cracking or separating due to fluctuating temperature and humidity, vibrations from movement inside the home, and gravity.

There are several things you should not do when installing drywall. Common mistakes include: adding too many screws, over-sanding, not adding backing support, and installing drywall unevenly. You also should avoid screwing into the same place twice, installing Sheetrock with tapered edges on the outside, and making too many joints.

Although they have similar applications, spackle and joint compound are not the same. Their primary differences lie in their composition, consistency, and ideal use cases.

Spackle is composed of gypsum and binding agents, making it thicker than joint compound. It dries quickly and is easy to sand, which makes it ideal for small wall repair projects like filling nail holes or patching minor damage.

Joint compound, also known as drywall mud, consists of limestone and gypsum. It is primarily used for large-scale projects, such as taping and finishing the seams on newly installed drywall. It tends to shrink more than spackle and can be more difficult to spread.

While both products can be used to fill small depressions and cracks, spackle cannot replace joint compound for taping and mudding new drywall. Conversely, you can often use joint compound for small patching jobs typically done with spackle.

The Pierz, MN homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.