Get matched with top sink installation pros in Quincy, MI

Drop-in sinks, also known as top-mount, are the easiest to install, especially when they fit the existing sinkhole. Drop-in sinks sit on top of the counter and have a raised edge to keep water from splashing onto the floor. They come in different styles to match your kitchen design.

Vanities may come with a countertop and sink but won’t include faucets. You’ll need to purchase your faucets separately from a home improvement or hardware store. When shopping for a fixture, you’ll have plenty of bathroom faucet types to choose from. Think about your vanity and bathroom aesthetics and what you need when deciding. Single-handle and centerset faucets work well in any space, while widespread, bridge, and wall-mount fixtures work in modern bathrooms.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Once you have your garbage disposal disconnected, you can remove the mounting bracket by unscrewing the bolts that are holding the bracket. You can back them out just enough to pop off the snap ring, which prevents the bottom portion of the bracket from disconnecting from the top when you unscrew the bolts. Use a regular screwdriver to pop off the snap ring, and the rest of the components should fall off by themselves.