Best countertop and backsplash pros near Otsego, MI

While porcelain countertops are durable and don’t chip easily once installed, they aren’t chip-proof. If they’re subject to blunt force, chips, cracks, or other damage can occur. Unless you’re very confident in your installation abilities, hiring a local countertop installation company will reduce the risk of damage.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

No, you should not put hot pots or pans directly on epoxy countertops, as this can cause permanent damage. While epoxy is heat-resistant, it is not fully heatproof. Epoxy countertops can typically withstand temperatures ranging from 135°F to 300°F, but cookware directly from a stove or oven can reach much higher temperatures (300°F to 500°F). Placing an extremely hot item on the surface can cause it to melt, soften, or discolor. To protect the integrity and appearance of your countertops, always use a trivet, hot pad, pot holder, or other heat-resistant barrier before setting down hot cookware.

Yes, it is often possible to replace an undermount sink without removing the countertop, but success can depend on the countertop material. For materials like granite, the process is relatively straightforward. However, laminate or uniquely shaped countertops might need to be removed or modified.

The process typically involves shutting off the water supply, disconnecting the drain and plumbing pipes, cutting through the old silicone seal, and carefully lowering the sink from below. This requires a good understanding of plumbing and the right tools. If you are not confident in performing the replacement yourself, it is recommended to hire a countertop specialist or a plumber to handle the task.