Top-rated countertop and backsplash pros.

Get matched with top countertop and backsplash pros in Hancock, MI

Enter your zip and get matched with up to 5 pros

Need a pro for your countertop and backsplash service project in Hancock, MI?

Select your specific project to find the pro for you.

Verified Reviews for Countertop And Backsplash Service pros in Hancock, MI

*The Angi rating for Countertop And Backsplash Service companies in Hancock, MI is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Countertop And Backsplash Service needs.

*The HomeAdvisor rating for Countertop And Backsplash Service companies in Hancock, MI is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Countertop And Backsplash Service needs.

Last update on July 03, 2026

Find Countertop and backsplash pros in Hancock

Avatar for WELCH TILE & MARBLE
WELCH TILE & MARBLE
4.9(
11
)
Laminate Countertops - InstallLaminate Countertops - RepairSolid Surface Countertops - Install (Concrete, Stainless Steel, etc)+3 more

Serving Hancock, MI and surrounding areas

In business since 1987

Free estimates

Credit card accepted

"Brady came and gave me an estimate.  They were able to start the work the next day.  It went quite well.  They ran into a slight problem in that some of the sub floor came up with the tile.  But it did not result in much of a price increase.  The floor was extremely uneven, but after they were finished, it was even and ready for us to install our floating floor.  They did a great job.
"
Recommended by100%of homeowners
Request Quote
Countertops and Backsplashes questions, answered by experts

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.

The standard kitchen countertop height is 36 inches, so a 37-inch countertop should work fine. However, if you’re 5’4” or shorter, a 37-inch countertop might be too high. Ideally, the countertop will be three to four inches below your elbows.

If you are building a laminate countertop from scratch, instead of buying premade laminate countertops, you can use particle board underneath the laminate. You will need to use a sheet of particle board for the substrate, along with four-inch strips underneath the edges. For proper installation, make sure that any seams are level and use a sander as necessary before installing the laminate.

You can cut countertops without chipping by using your saw correctly and having a new fine-toothed blade. You can also put masking tape on the front of the countertop material across the cut line and cut from front to back. However, it is very hard to cut countertops without chipping them, especially if they are made of stone or more fragile materials like laminate. The best advice is to know how to use the equipment, use the correct cutting method for the material, cut from back to front, move slowly, and practice on scrap material first.

Countertops typically hang over base cabinets by 1.5 inches. This slight overhang protects cabinet faces from spills and provides a finished look. The overhang may extend 12 inches or more for kitchen islands or breakfast bars to allow for seating and comfortable eating.

The Hancock, MI homeowners’ guide to countertop and backsplash services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles