Get matched with top toilet pros in Grayling, MI

Toilet handles can get stuck for a couple of reasons, but it’s commonly an issue with the chain. Remove the lid and check the chain’s connection, running from the flapper to the handle arm. Sometimes the chain gets snagged on or against another part of the tank. 

The chain might not have the right tension. For example, a chain that’s too short can make the handle feel stuck. Check that there’s some slack in the chain. Old, worn-out flappers can get stuck, too. In this case, you’ll need to see which size toilet flapper you need.

Basement toilets don’t always need a pump. However, it is the most common setup because plumbing systems use gravity to move waste away from the home. Basement toilets often sit below the home’s main sewage system, and installing a sewage ejector pump pushes the wastewater and sewage up to the main sewer line. Alternatively, you can use an upflush or macerator toilet that breaks down the waste and pushes it straight to the main sewer line rather than via a sewer line from the bathroom.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

The most common reasons a toilet won’t stop running are a faulty flapper or fill valve, improper fill height, or incorrect chain length. Luckily, all these issues are relatively easy to fix with parts you can find at a local hardware store. You can also call a plumber or toilet repair professional to solve the problem.