Get matched with top pressure washers in Flushing, MI

You should avoid using a pressure washer on any surface or item that could be damaged by the high-pressure spray, as some materials are too delicate to withstand the force.

Key items and surfaces to avoid include:

• Electrical Components: Never pressure wash electrical systems, as water can cause short-circuits and create a safety hazard. This includes utility meters, breaker boxes, electrical outlets, generators, and HVAC or air conditioner units.

• Delicate and Fragile Materials: Fragile items can crack, shatter, or be stripped by the pressure. Avoid pressure washing windows, glass, light fixtures, shingled roofs (especially asphalt), and stucco.

• Painted, Stained, or Sealed Surfaces: Unless your goal is to strip the finish, do not pressure wash painted surfaces, stained wood (like decks), or anything with a protective seal that could be stripped away. Be especially cautious with older surfaces that may contain lead paint.

• Soft Woods and Certain Decking: Delicate surfaces like softwood, composite decking, and antique or wooden patio furniture can be etched or damaged. If you must wash wood, use a lower-powered pressure washer with a wide-angle nozzle to prevent damage.

• Living Things: Never use a pressure washer on people, pets, or plants. The force can cause serious injury and will destroy landscaping.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

It usually takes about two to four hours to pressure wash a 2,000-square-foot home. The exact time depends on how much dirt there is, the type of siding, and whether you’re doing it yourself or hiring a professional pressure washing service. A DIY job can take an average of six to eight hours, but you should plan for it to take an entire day. A pro can get the job done quicker.

It is generally not recommended to use dish soap in a pressure washer. Dishwashing liquid is formulated for cooler water, and the warmer water used in a pressure washer can create excessive suds, potentially damaging the machine's tubing and other components. Always check the manufacturer’s instructions for recommended detergents. If you find yourself in a pinch, you can try a highly diluted solution, such as one tablespoon of dish soap per 1.5 quarts of water, to avoid clogging the machine.