Top-rated structural engineers.

Get matched with top structural engineers in Berrien Springs, MI

Enter your zip and get matched with up to 5 pros

Need a pro for your structural engineering project in Berrien Springs, MI?

Select your specific project to find the pro for you.

Verified Reviews for Structural Engineering pros in Berrien Springs, MI

*The Angi rating for Structural Engineering companies in Berrien Springs, MI is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Structural Engineering needs.

*The HomeAdvisor rating for Structural Engineering companies in Berrien Springs, MI is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Structural Engineering needs.

Last update on September 16, 2025

Find Structural engineers in Berrien Springs

Avatar for American Basement Solutions
American Basement Solutions
4.3(
46
)

Serving Berrien Springs, MI and surrounding areas

In business since 1992

Credit card accepted

"Work went well. Crew arrived when scheduled and on time. Seemed very professional, friendly, and conscientious. They showed me what they were doing and how the piers would be installed. I gathered 5 quotes for the job and they were the most professional/competitive of everyone I spoke with and I was not disappointed. Only minor complaint would be that it seemed the grading on the back fill was left a bit high. I was told it would settle, but I doubt it will settle that much. Not a big deal--I would still highly recommend them."
Additional Photos
Additional Photos
Additional Photos
Recommended by85%of homeowners
Request Quote
Structural Engineering questions, answered by experts

The 10 10 rule describes the formula most contractors use to determine how much to charge for a job. Allowing for 10% overhead above the total projected cost to do the work and 10% profit sets a contractor up for success, even if there are delays or other problems on the project. This formula isn’t a hard-and-fast rule, but it is a ballpark figure to begin with when estimating your expenses on a job.

Yes, they offer plans for repairs or reinforcements to address issues.

A 4-inch-thick concrete slab can support around 4,000 pounds per square foot if a contractor reinforces the slab with rebar, while that same slab without reinforcements will support closer to 1,000 pounds. For the purposes of a patio, 4 inches in thickness without reinforcement should suffice unless you’re installing heavy kitchen equipment or a hot tub on it. In those cases, reinforcing your slab and sticking with 4 inches of thickness should provide plenty of strength.

Yes, walls on the top floor can be load-bearing if stacked on the floor’s foundation.

In framing, studs are placed at 16-inch intervals to coincide with the typical spacing of wall materials such as drywall or plywood. This spacing is called "on-center" and is necessary for maintaining structural stability and efficient use of materials. The 16-inch spacing also helps to distribute the weight evenly across the building's structure. For those looking to cut material costs and improve energy efficiency, 24-inch stud spacing can be employed through a method called "advanced framing". This requires careful planning and adherence to local building codes to ensure structural integrity.

The Berrien Springs, MI homeowners’ guide to structural engineering services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"