Get matched with top deck maintenance specialists in Beaver Island, MI

The best way to clean your decking is to clear debris from the gaps between the boards, sweep the surface, rinse it, apply cleaner, rinse again, and let it dry fully. A homemade deck cleaner made of two gallons of warm water and 1/2 cup vinegar is a simple cleaning solution for both wood and composite decking. You can sprinkle baking soda on any spots with mold or mildew, then scrub the area and rinse clean. 

It’s best to prime composite decking before painting. This promotes better paint adhesion, helps create a smooth finish, and can mean the paint job will last longer. Always follow the manufacturer’s instructions for application, allow ample primer drying time before painting (typically 24 to 48 hours), and thoroughly clean the deck boards to promote the best adhesion.

Staining and sealing the underside of a deck creates a moisture barrier but traps water in the boards, quickly leading to rot. No matter how well you seal the above deck, water still gets through via nails and screw heads on the surface. Allow this water to flow naturally under the deck, where it is routed through the drainage system.

The best and fastest way to remove paint from a deck often involves combining a chemical stripper with a pressure washer. Gel-based paint strippers are highly recommended because their thick consistency makes them less messy and easier to apply than liquid strippers. After applying the stripper to loosen the paint, you can use a pressure washer to efficiently wash away the residue. When using a pressure washer for this task, it's important to use a low pressure (under 1000 PSI) to avoid forcing too much moisture into the wood, which could lead to mildew or rot.