Top-rated toilet pros.

Best toilet pros near Turner, ME

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Turner, ME?

Select your specific project to find the pro for you.

TRUSTED BY TURNER, ME HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon63
    Verified toilet services reviews

Top-Rated Toilet pros in Turner - Updated Nov 2026

Avatar for swb plumbing/hvac
swb plumbing/hvac
5.0(
15
)
Faucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Turner, ME and surrounding areas

Approved

In business since 2023

Free estimates

Emergency services offered

"Seth was very prompt and worked hard to find the parts and solution to an old bath faucet with a bad leak. He kept me informed about the process and alternatives for the repair. I would recommend him for future repairs."
New condensate line property piped into existing house sewer to code
1 1/2” water mains
3 zone heat pump install
Install condensate pump and neutralizer to bring existing boiler upto code.
1 1/2” water mains insulated after we installed them.

+10

Response time1 day
Response rate100%
28 neighbors recently requested a quote
Gotta Go Plumbing, LLC
4.7(
19
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or Replace

Serving Turner, ME and surrounding areas

In business since 2000

Free estimates

Credit card accepted

"Bob was extremely friendly and worked diligently to get our shower working properly again. He came out at a momentâ s notice and was very knowledgeable. I would highly recommend Bob to anyone looking for a reputable, hard working plumber!"
Response time1 day
Recommended by94%of homeowners
Showing 1-10 of 43
Toilets FAQs, answered by experts

A high pitch noise after flushing is likely caused by the fill valve being clogged with debris. You can repair this and eliminate the noise by removing the fill valve from the tank, and then cleaning the valve screen. Place the clean fill valve back in the tank and flush as normal.

To test for toilet leaks, use water coloring in the water tank and see if the water slips into the bowl from the tank. This test will indicate if there’s a problem with the flapper or refill tube. You can also put water coloring in the bowl of the toilet to see if there is a leak there. If there is, you should see the colored water on the outside of the toilet bowl or on the floor. 

A bit of water in the bowl can help unclog a toilet, especially if you're using a plunger. However, if the bowl is full to the brim, you'll need to strap on gloves and remove some of the wastewater in a cup or container so it doesn't overflow when you try to unblock the pipe. If you're concerned about it filling further, manually close the flapper in the toilet tank or turn off the water supply to the toilet.

Ensuring your toilet will fit starts with measuring the rough-in, but there are a few other factors to consider. The toilet tank's height and the toilet's depth should fit comfortably within the bathroom’s current setup. When considering depth, look at the walking space around the toilet to ensure it fits in the bathroom.

Sealant doesn’t need to be applied to the bolts, but it can be a good way to stop an active leak in the moment. However, don’t rely on it as a cure-all; instead, make sure to fix the problem at the source by changing or tightening the bolts. 

If you do use sealant, make sure to spread it thickly and evenly across the bolts and the tank's porcelain.

The Turner, ME homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.