Get matched with top toilet pros in Fayette, ME

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

To test for toilet leaks, use water coloring in the water tank and see if the water slips into the bowl from the tank. This test will indicate if there’s a problem with the flapper or refill tube. You can also put water coloring in the bowl of the toilet to see if there is a leak there. If there is, you should see the colored water on the outside of the toilet bowl or on the floor. 

Basement toilets don’t always need a pump. However, it is the most common setup because plumbing systems use gravity to move waste away from the home. Basement toilets often sit below the home’s main sewage system, and installing a sewage ejector pump pushes the wastewater and sewage up to the main sewer line. Alternatively, you can use an upflush or macerator toilet that breaks down the waste and pushes it straight to the main sewer line rather than via a sewer line from the bathroom.

The cost to install a new toilet typically runs from $225 to $530. This doesn’t include the price of the toilet itself, which can cost $90 to $1,500 depending on the model and features you choose. You can save money if you choose to install a toilet yourself. However, you might want to hire a pro for this project.

"Due to the many complexities of replacing a toilet flange, it is typically a job best left to the pros," says Jeff Botelho, Angi Expert Review Board member and plumber. "Many times it isn't as simple and straightforward as 'pop off the old one and pop on a new one' because the flange is either glued on (PVC/ABS), soldered on (brass/copper), or caulked in place with a lead & oakum joint (cast iron) and none of these things can be easily reversed without years of training and repetitive practice."