Get matched with top toilet pros in Readfield, ME

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.