Get matched with top drywall pros in New Harbor, ME

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

Yes, as drywall mud is going to have some uneven spots and bumps after application. Such imperfections are going to be visible after everything dries and even after you paint the wall, so you want to remove them. Learning how to sand drywall, taking your time, and following drywall sanding tips can help you have the best results.

In framing, studs are placed at 16-inch intervals to coincide with the typical spacing of wall materials such as drywall or plywood. This spacing is called "on-center" and is necessary for maintaining structural stability and efficient use of materials. The 16-inch spacing also helps to distribute the weight evenly across the building's structure. For those looking to cut material costs and improve energy efficiency, 24-inch stud spacing can be employed through a method called "advanced framing". This requires careful planning and adherence to local building codes to ensure structural integrity.

Installing drywall will cost between $1.50 and $3 per square foot for materials, labor, and finishing, which is quite a bit lower than the average of $9 to $13 per square foot for a drop-tile ceiling. So, while drop ceilings allow more design flexibility, provide easy access to utility lines above them, and are often much easier and less expensive to repair, they do cost more upfront. You can minimize your drop ceiling cost by opting for more affordable fiberboard panels, although some homeowners don’t like the look of this material.