Top-rated buffing and polishing pros.

Get matched with top buffing and polishing pros in Clinton, ME

Enter your zip and get matched with up to 5 pros

Need a pro for your buffing and polishing project in Clinton, ME?

Select your specific project to find the pro for you.

Find Buffing and polishing pros in Clinton

Avatar for New England Home Renovations LLC
New England Home Renovations LLC
4.0(
311
)

Serving Clinton, ME and surrounding areas

In business since 1983

Free estimates

Emergency services offered

"Everything went wonderfully with this company.  They were very professional, listened to exactly what my problem was, and explained to me how they were going to diagnose the problem and/or solve it before doing any actual work.  Once they started, the team (three people came) worked together like a well-oiled machine.  One was in the room with diagnostics, one was at the fuse box looking for possible problems there, and the third went into the crawlspace beneath our house to look at the physical wiring.  Once the problem was found (there was a faulty wire beneath the house that had come loose from the junction box), it was fixed and tested within minutes and another full diagnostic was done to make sure there were no other possible issues.  They cleaned up after themselves very neatly.  They also replaced the light switch with a dimmer switch at no extra cost!  Well within my budget, and came in even lower than their original (FREE) estimate!  I would highly recommend this company to anyone in the Bergen County area.
"
Before
After's
New boiler install
Removal of cast Iron to PVC.
Additional Photos

+37

Recommended by89%of homeowners
Avatar for Winn Construction
Winn Construction
5.0(
1
)

Serving Clinton, ME and surrounding areas

Free estimates

Emergency services offered

Credit card accepted

"My son flooded my entire house last summer and as a result my home needed a 3 story remodel. Matthew was professional, on time and exceeded my expectations. I am in love with the work he did on my home to bring it from the 1970s to something modern and beautiful. Thank you!"
Upstairs water damage leaked into the living room area. Ceiling was molded, wood was water damaged and the flooring was destroyed.
Removal and replacement of ceilings and floors, removed wall paneling and replaced with sheet rock, installed raw pine ceilings with lighting throughout
Recommended by100%of homeowners
Buffing and Polishing questions, answered by experts

Buffing will only remove scratches at the surface level of your flooring. You may also need to apply hardwood floor wax to restore the wax layer. To remove deeper scratches, you’ll need another floor repair method like sanding; however, if you sand the floor, you’ll also need to stain and seal it.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

It depends on the material. Sandstone, slate, and granite can be slippery in wet weather. Applying a sealant to the stone can often stop it from absorbing moisture and may reduce the likelihood of slipping. If you're concerned about losing footing, a safer option might be bluestone or concrete.

Cracks, chips, stains, and worn-out sealant are common issues requiring repair.

A water-based, low- or no-VOC sealer is typically a good choice for marble countertops. Choose a sealant that is certified safe for contact with food when applying to kitchen countertops. For high-traffic areas, look for formulas that have heat-resistant and acid-resistant features. While there are economical and convenient spray-on sealers, they don’t coat the surface as effectively as the ones you apply with a pad or brush. 

The Clinton, ME homeowners’ guide to buffing and polishing services

From average costs to expert advice, get all the answers you need to get your job done.