Get matched with top electricians in Bucksport, ME

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

If half of a string of Christmas lights is out, it is likely because of a single burned-out, loose, or broken bulb within that section. Long strands of lights often contain more than one circuit, so when one bulb fails, it can cause the entire circuit (or half the strand) to go dark. To fix this, inspect the unlit section and test each bulb to ensure it is tight and functioning properly. Replacing the faulty bulb or repairing a damaged shunt will typically solve the problem.

You can identify Federal Pacific Stab-Lok® breakers by the label on the front of the panel that says “Federal Pacific” or “FPE” and the breaker itself should say “Stab-Lok®” either on the face of the panel or a label inside the panel door. The Stab-Lok® breakers are also usually red on the breaker switch.

The number of outlets and lights you can safely run on a single circuit depends on the circuit's amperage and local electrical codes. A general rule is to allow one outlet or light fixture per 1.5 amps, keeping the total load under 80% of the circuit breaker's capacity. For example, a 15-amp circuit can typically support up to eight outlets or lights, while a 20-amp circuit can accommodate up to ten. Always consider the combined power usage of all connected devices and fixtures to prevent overloading. For specific guidelines and to ensure safety, it is best to consult local electrical codes or a licensed electrician.