Top-rated toilet pros.

Get matched with top toilet pros in Brooklyn, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Brooklyn, MD?

Select your specific project to find the pro for you.

TRUSTED BY BROOKLYN, MD HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon2.7k+
    Verified toilet services reviews

Find Toilet pros in Brooklyn

Avatar for Remedy Plumbing & Drain Cleaning, LLC
Remedy Plumbing & Drain Cleaning, LLC
4.7(
731
)
Drain Clog or Blockage - Clear

Serving Brooklyn, MD and surrounding areas

Approved

In business since 2017

Emergency services offered

Warranties offered

"The total repair fixing two toilets took less then 30 minutes and I am very pleased with the outcome. Mr. Rema knew just what needed to be done to fix the problem and NO mess after. Thank you Rema and your helper. I plan to use Remedy Plumbing for all my plumbing jobs!"
Response time1 day
41 neighbors recently requested a quote
Recommended by93%of homeowners
Avatar for Water Field, LLC
Water Field, LLC
4.8(
133
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Brooklyn, MD and surrounding areas

Approved

In business since 2014

Emergency services offered

Warranties offered

"Finally! When friends ask if I know of a reliable, honest, plumber at reasonable cost, I have found one to give as a referral in Water Field, LLC. Tes arrived on-time and assessed what was needed to correct my pipe leak problem in short order. While waiting for his repair work on the leaky pipe to cool, Tes offered to check all the other fixtures in my home to ensure everything was in order. When I mentioned one of my toilets was not properly anchored to the floor, an annoyance to me for quite some time, he fixed it at minimal cost. Water Field, LLC is now officially my go-to plumber. Bill Adams Windsor Mill, Maryland"
Internal Excavation
Sewer line extention
Gas water heater
Gas water heater
Sewer line replacement

+4

Response time20 mins
2 neighbors recently requested a quote
Recommended by99%of homeowners
Avatar for Steve's Monster Plumbing and Drain Cleaning
Steve's Monster Plumbing and Drain Cleaning
5.0(
10
)
Drain Clog or Blockage - Clear

Serving Brooklyn, MD and surrounding areas

Approved

In business since 2019

Free estimates

Customers say: Quick response

"Supper job, this was a difficult job. I did not know what was wrong with the toilet clog, it flooded out two floors over 7000.00. I first called Roto Rooter the fix it for two days. We were referred to Monster Plumbing and he came fixed it and told me if I had any more problems to call him again. Two later again toilet clogged. He came out with a scope and found some type of wiring that the builders dropped in during our rebuild after a fire. Pulled it out and what a relief super job!!! He was very assertive that he would find the problem. GREAT JOB!!!"
Water heater installs
Upon arrival
Complete
Response time2 hrs
Response rate94%
Recommended by90%of homeowners
...
Showing 1-10 of 379
Toilets questions, answered by experts

After flushing the toilet, you should have about half a tank full of water. While the exact amount of water you’ll have will vary, you want to make sure you have enough to cover the bottom of the bowl and enough to sit above the P-trap drain. While low water in your toilet bowl can indicate a problem, too much water can also be cause for concern.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

No, your toilet tank should not empty completely when you flush. Although the water level will dip a lot after you flush, it shouldn’t be totally empty. If your tank is empty, you might have issues with your fill valve, float ball, or toilet trip lever. You should check all of your toilet parts to ensure they’re working correctly and make any necessary adjustments.

Sealant doesn’t need to be applied to the bolts, but it can be a good way to stop an active leak in the moment. However, don’t rely on it as a cure-all; instead, make sure to fix the problem at the source by changing or tightening the bolts. 

If you do use sealant, make sure to spread it thickly and evenly across the bolts and the tank's porcelain.

Your toilet handle might not come back up if the nut is loose or the bolt threads are stripped. Try to tighten the mounting nut and wrap plumber’s tape around the handle bolt to fix stripped threads. It’s possible the handle was improperly installed. If that’s the case, you can use the instructions above to correct the handle’s position. 

The Brooklyn, MD homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.