Get matched with top water heater pros in Barnstable, MA

If your system is not vented properly, you could experience what’s called backdrafting. Backdrafting is when your ventilation system isn’t working as it should, and instead of releasing gases outside, they get trapped inside your home. 

Gas and propane water heaters create a few types of combustion gases, but the most dangerous is carbon monoxide. If there’s too much build-up of these gases inside your home, it can lead to carbon monoxide poisoning.

While a water heater explosion is rare, it is a serious danger. Be aware of these critical warning signs:

• Sulfur or Rotten Egg Smell: This is a major red flag, especially for gas water heaters. It can indicate a gas leak, which could ignite and cause an explosion.

• Leaking Pressure Valve: If the temperature and pressure (T&P) relief valve is leaking, it may not be able to properly regulate internal pressure, creating a risk of bursting.

• Shaking or Rumbling: Loud rumbling or shaking from the tank can be a sign of extreme pressure buildup.

• Excessive Heat: If the exterior of the water heater feels unusually hot to the touch, the unit may be overheating dangerously.

• Rust-Colored Water: This can be a symptom of severe internal corrosion that compromises the tank's integrity.

If you notice any of these signs, especially a gas smell, you must act immediately. Shut off the gas supply to the water heater and call a professional plumber right away to prevent a potential disaster.

No. Expansion tanks must be installed on the supply side (where heated water flows out) of the boiler. There’s also a list of other requirements for most boilers, including being above the pressure relief valves, being on the inner side of any circulator, and more. Your installation manual should have more information on expansion tank installation requirements and what sort of tank the system is made for.

No, you’ll need to drain the tank before changing a water heater element, as the water heater element sticks through the side of the tank and uses a gasket to prevent water from pouring out. However, you don’t always need to drain it completely. If you’re only replacing the upper heating element, you can drain the tank until the water line is below the element. If you’re replacing the lower element, you’ll need to drain the whole thing.