Get matched with top drywall pros in New Sarpy, LA

Yes, it matters which side of drywall you use. One side is smooth, and the other is rough. The smooth side should be facing outward, toward the room, while the rough side should be hidden and facing the studs and framing of the house. The smooth side will be easier to apply tape, joint compound, and, later, paint to.

Furring strips, thin strips of wood or metal, are not always required for ceiling drywall installation. If the ceiling surface is even and in good condition, drywall can be directly attached to the ceiling joists using screws. However, furring strips become essential when dealing with irregular surfaces or when additional insulation or soundproofing is needed. They create a level substrate for attaching the drywall. Ultimately, the decision to use furring strips depends on the condition of the existing ceiling and the specific requirements of the project.

Bump-out additions can add some space to a closet without requiring any significant structural work. This entails pushing back the existing rear or side of the closet, simply moving the wall into either an adjacent room or unused space. For ground-floor closets, this could even be extended to the exterior of the home, but that has its own complications. Bump-outs are a good discussion to have with your contractor if you’re just looking to increase the space a little—not renovate the entire closet space.

Whether you can reuse a drywall anchor or not depends on the type. Plastic expansion anchors and plastic self-drilling anchors, which expand once screwed into the wall, are single-use only. You can't straighten and reuse them after removing them from the wall.

Metal toggle bolts can be reused, provided you can successfully remove the toggle from behind the wall. Once you remove the bolt, the toggle often falls down and can be difficult to retrieve without removing the drywall.