Get matched with top pre-made cabinet pros in Loranger, LA

It’s best to stick with lightweight cabinets, such as medium-density fiberboard, if you don’t have a wall stud to secure them to. Unless you’re attaching the cabinet to a flat board attached to wall studs, it’s best not to risk it with heavy cabinetry or contents. Solid wood cabinets and heavy dishware should be avoided if you cannot secure the cabinet to a wall stud. Either way, always check the weight on your wall anchors and be sure not to exceed it.

The 1/3 rule is a design guideline used by interior designers and cabinet installers to select appropriately sized pulls for cabinets and drawers. The rule suggests that for a balanced and cohesive look, a cabinet pull should be approximately one-third the height of the cabinet door or one-third the width of the drawer face. This guideline helps create a symmetrical appearance because the human eye tends to follow the length of the pull across the cabinet face.

While the 1/3 rule is a helpful starting point, it is not the only option. If a measurement falls between available pull sizes, it's generally best to size up. For an ultra-contemporary aesthetic, you can also opt for full-width pulls that span the entire drawer.

Some municipalities require permits for wall-mounted furniture installations, particularly when structural modifications are necessary. Always make sure to check local building codes before starting your Murphy bed installation project. Your Murphy bed installer will be familiar with local codes and handle the permitting process, ensuring your project complies with all relevant regulations.

There are three primary ways to attach upper kitchen cabinets to a wall, and installers may use more than one method at a time. The most common method is to drive screws through the back of the cabinets and into studs in the wall behind. Sometimes cabinets are glued to the wall with strong adhesive. Often a combination of screws and adhesive is desirable. The last way is by hanging the cabinets on hardware brackets that attach to the wall before cabinet installation.