Top-rated asphalt driveway pros.

Get matched with top asphalt driveway pros in Frankfort, KY

Enter your zip and get matched with up to 5 pros

Need a pro for your asphalt driveway service project in Frankfort, KY?

Select your specific project to find the pro for you.

Find Asphalt driveway pros in Frankfort

Avatar for Coaty & The Crew
Coaty & The Crew
4.8(
105
)
Concrete Driveways - Install

Serving Frankfort, KY and surrounding areas

Approved

In business since 2025

Free estimates

Warranties offered

"I’m obsessed with the new driveway! Our old driveway was run down and just needed to be replaced. It compliments our home very well and makes it look as if it wasn’t built over 100 years ago."
Stamped Concrete
Stamped Concrete
Stamped Concrete
Stamped Concrete
Stamped Concrete

+47

36 neighbors recently requested a quote
Recommended by1%of homeowners
Avatar for Brian Kibler
Brian Kibler
4.7(
5
)
Concrete Driveways & Floors - Install- For BusinessConcrete Driveways - Install

Serving Frankfort, KY and surrounding areas

Approved

In business since 2021

Free estimates

Small jobs welcome

"Brian responded to to my request for an estimate in a timely manner. He came out for the estimate the next day and worked diligently and methodically to get the maximum amount of work completed in a day. He did an excellent job for our entire court replacing sidewalks. We would hire him again!"
Brian concrete work
Brian concrete work
Brian concrete work
Brian concrete work
Brian concrete work

+34

Response time1 day
Recommended by80%of homeowners
...
Showing 1-10 of 206
Asphalt Driveways questions, answered by experts

Costs range from $3 to $7 per square foot, depending on the area size and project scope.

The answer to whether or not you need to get a permit before you start your driveway can vary widely based on local ordinances and the scope of your driveway ideas. In most urban and suburban areas, a permit is needed before building a new driveway to ensure that a homeowner is using safe materials and proper drainage practices while designing and constructing a new driveway. In some rural areas, a homeowner may not be required to apply for a permit. When building a new driveway on your own, always check with your local building department to see if you need to request a permit. When hiring a driveway contractor, verify that the right permits are being used before driveway construction begins.

An ideal driveway gradient is between 2% and 5%. Anything lower than 1% or higher than 15% can cause problems for your car or property. A driveway with less than a 1% slope increases your likelihood of flooding and water damage, while a driveway with a 15% grade or higher can be too steep for safe traveling.

Instead of a set number of types, asphalt comes in variations designed for different needs. Some are categorized by temperature—hot mix, warm mix, and cold mix. Others are sorted by composition, like dense-graded, gap-graded (such as Stone Matrix Asphalt), porous, and mastic asphalt. There are also modified versions with added compounds like polymers, rubber, or emulsions. Instead of focusing on a number, it may be more useful to understand how contractors customize asphalt for durability, climate, and traffic conditions.

The average cost of 1,500 square feet of asphalt ranges from about $10,500 to $22,500, depending on location, thickness, base material, and how accessible the job site is to crews and equipment. Keep in mind that your asphalt material cost may vary depending on its type, ranging from porous asphalt to heated blacktop. Standard asphalt costs $7 to $13 per square foot.

The Frankfort, KY homeowners’ guide to asphalt driveway services

From average costs to expert advice, get all the answers you need to get your job done.