Get matched with top pool table assembly pros in Rolling Meadows, IL

Size is the main difference between a pool and a spool. Spools are typically about half the size of an average pool, so they’re ideal for yards without the space for a full-sized pool. Spools are also easier to heat, so they tend to be a higher temperature than pools and can be adjusted to get as hot as a spa when it’s time for a relaxing soak. Spools also contain jets and blowers, while most pools do not.

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

A solar cover can heat your pool anywhere from 5 to 15 degrees Fahrenheit over the course of 6 to 12 hours, depending on how much full sun your pool gets and how big it is. When used in conjunction with a solar pool heater, your pool will heat up even faster, all while using less energy than a traditional pool heater.

If you’re wondering how to find a leak in an aboveground pool, the process is the same as it is for an in-ground pool. Note that the vinyl liner in aboveground pools is fairly thin, so sharp objects easily puncture it. Additionally, the liner can wear down after constant exposure to pool chemicals, especially when chlorine levels are higher than they should be. For these reasons, small holes in the vinyl liner often cause leaks, but you can easily detect them with the dye test.