Best sink repair pros near Pinehurst, ID

Many parts of your plumbing system can fail, but clogged drains are one of the biggest plumbing problems you’ll likely encounter. From your kitchen sink, bathroom sink, or bathtub, there are plenty of opportunities for gunk, hair, food scraps, and more to get stuck in drains. When this happens, water will slowly drain, leading to standing water, bad odors, drain flies, and other issues.

Many homeowners can handle a minor clog themselves, but if you have a clog in your main line, you’re best off hiring a local plumber to get the drain back to its normal flow rate.

Try to tighten the clevis crew and adjust the lift rod if your sink stopper won’t stay up. Sometimes your screws became too loose over time, and as a result, there wasn’t enough resistance to keep the sink stopper up. If a damaged lift rod is the cause of the problem, you will need to replace it with a new rod.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Deteriorated seals, O-rings, or gaskets are common culprits behind a leaky sink after you’ve turned off the water—especially if your sink is older than 15 years. Inspect each of these mechanisms in your sink for signs of corrosion or looseness, then replace the worn-out part to fix it. Older sinks may be worth replacing if several of the parts are worn-out.